– Higher sludge/grit removal rate than traditional
travelling bridge scrapers which saves a huge amount of pipe and pump retrofits and in the end cost.
– Low maintenance
– Low energy consumption
– Easy to cover tanks for odour control and for
increased access to the area
– No hydraulic oil leakage, non-grease bearings,
no oil leakage
At aerated grit traps after the inlet screens at municipal and industrial waste water treatment plants.
The motored gear is assembled on a vertically adjustable motor plate for tensioning of the power transmission chain. The transmission chain is made of acetal resin and is lubricated by the tank water. All moving parts are covered and protected by a light weight easy access aluminum hood.
The shaft is designed as a stainless steel tube with welded flanges. Plastic split sprockets are bolted to the flanges. The split sprockets enable maintenance without disassembly of the driveshaft. The drive shaft’s bearings are spherical long life heavy duty plastic bearings. The bearings are lubricated by the tank water. No additional greasing is needed.
Plastic hubs with sprockets are fixed with collars on stationary solid stub end shafts or tube shaft similar to the drive shaft for wide grit trap tanks. The shafts are secured in brackets that are welded to anchor bolted wall plates. Collector chain tensioning is available as an option.
The flights are made of stainless steel to be able to handle the higher wear and tear that occurs when scraping grit. It’s excellent corrosion resistance, strong and heavy duty design resist high sludge loads without compromising the safe operation.
We define the suitable scraper profile based on tank dimensions and sludge load, and supply scrapers to various tank configurations. We have a vast experience of specially designed configurations.
The scrapers are equipped with skids and filler blocks for the strongest possible fixation of the chain’s attachment link. A number of scrapers are equipped with rubber strips to sweep the entire tank floor.
Bottom strips and wall rails
Plastic skid strips on the tank floor and stainless steel wall rails guides keep the scrapers in position.
Our design makes the use of additional nylon wear strips on the wall rails unnecessary which reduces maintenance cost.
Scraper collector chains
The plastic collector chain type NCS 720S is made of an acetal resin which is a highly suitable plastic when it comes to chemical-, corrosion- and wear resistance and yet does not compromise on the strength or durability of the chain.
The chain pitch is 6” or ~152 mm and the maximum break load is over 3100 kg. The chain is locked with simple snap-in pins.
Removal/installation is kept very simple with our special tool.